Jump to content

robertcs49

Member
  • Content Count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Field of Work
    Other
  • Country
    US
  • 3D printer
    Other

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. I did a manual pause and after inserting the nut restarted and, other than an obvious groove in the surface at the pause layer that runs the entire perimeter, it printed nicely.
  2. I have done a half dozen of these trying to get the nut house dimensioned correctly and there is never a problem with starting a new one. I will try a manual pause but I have had problems with doing that with this machine so we will see. Thanks.
  3. Smithy, thanks for the reply. The printer I am using is a Creality CR-10S. There does not seem to be anything unusual about the filament. As I watch the feeder operate the filament is moving when the feeder gear turns, either way; there is only just a very small amount of movement and seems to be random.
  4. My problem with this Pause at height/layer plugin is that after it pauses, and I have added a nut I want embedded, with the nozzle holding at the print temperature, upon restart it starts going through all the motions X, Y, and Z right to the finish but does not extrude any more material except the occasional blob. The extruder gear and idler can be seen moving back and forth in very small increments occasionally but otherwise doing nothing at all. The image shows the layer that it stopped with the nut in place and the results afterwards, just blobs, yet the printer continued on as if nothing were wrong right to completing the final layer and parking itself at home. And this happens using either height or layer option.
  5. My problem with this Pause at height/layer plugin is that after it pauses, and I have added a nut I want embedded, with the nozzle holding at the print temperature, upon restart it starts going through all the motions X, Y, and Z right to the finish but does not extrude any more material except the occasional blob. The extruder gear and idler can be seen moving back and forth some otherwise doing nothing at all. The image shows the layer that it stopped with the nut in place and the results afterwards, just blobs, yet the printer continued on as if nothing were wrong right to completing the final layer and parking itself at home. And this happens using either height or layer option.
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!