Hey PPL,
i am still happy that i could start Cura again, after upgrading to 3.4.1. from 3.3.1. , but i still expire near by same bug like i had before with other Versions.
When i still check my Printer Config, it says my Printer is offline and not active. Cura Makes Marlin/Skynet restart all the time and does not boot it again.
After i turned the Printer off and on again it still boots one times for a minute and starts reboot the Printer Board over and over.
I could not go to the Main Printer Menue again, like it did before for a moment.
On the first Picture is a strange failure meesage, i cant explain. Before that does pop up,it showed me Skynet is ready.
I would be thankfull for a Solution, how to make Cura work with my DIY Printer.
(AM8 BLV MGN12)