Jump to content

Alexglvr

Member
  • Posts

    4
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other
  • Country
    FR
  • Industry
    R&D / Exploration

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Alexglvr's Achievements

0

Reputation

  1. OK, thanks. I will then go back to 5.4 until the bug is solved!
  2. Hello, I updated to Cura 5.6.0 for my V400. I am making first layer test prints and I have an issue : the border of the part is printed fast whereas it is on first layer. Please see on preview.jpg : - Skirt (in blue) is printed slow which is normal - Grey first layer infill is printed slow, which is also normal as it is first layer - Yellow part (border of the first layer) is printed super fast I also linked my speed configuration. What did I miss? it is the first time I have this behavior... Thank you for your help, Alex
  3. Hello, Stringing is a bit of a mess... No other choice than making lots of tests. Increase travel speed to 150mm/sec, Increase retraction, add z up before retraction and level change (0,5mm was a good value for me), and at least try do decrease nozzle temp. in my case, nothing was working. I replaced the nozzle and it is great now hope it will help Alex
  4. Bonjour à tous Je suis nouveau dans le monde de l'impression 3D et sur le forum. Je me tourne vers vous aujourd'hui car j'ai un problème d'impression qui me rend fou... Même si j'arrive à faire des impressions "correctes", j'ai voulu optimiser mes réglages afin de tirer le maximum de mon Anet A8 modifiée. J'ai donc commencé par travailler sur le stringing...mais impossible de trouver les réglages qui vont biens. Je travaille pour le moment sur du PLA et J'ai commencé avec les réglages suivants: Puis j'ai augmenté la rétraction, la vitesse de rétraction, de déplacement, j'ai augmenté et diminué la température de la buse... etc. Dans tous les cas, des que j'augmente la rétraction pour obtenir une diminution sensible du stringing, je passe en sous extrusion et ce avant même que le stringing ne disparaisse complétement... Résultats : sans Z-Hop avec z-Hop de 0.5mm Merci pour votre aide, Alex
×
×
  • Create New...