Jump to content

CDG

Dormant
  • Posts

    1
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Ultimaker S5
  • Country
    AU
  • Industry
    (Product) design

CDG's Achievements

0

Reputation

  1. Hi UM Team, I have a brand new S5 that has been commissioned this week. - Latest Firmware Installed 5.0.19.20180622 - UM Tough PLA in Print Core 1 using 0.4AA - UM PVA in Print Core 2 using 0.4BB Three main issues I would love your help with: 1.0 Print Head Pause Blobs The printer seems to be pausing mid print and continuing to deposit a blob of plastic whilst paused before moving on to continue with print. It is even doing this pause/blob deposit during XY Head Calibration sequence. (see large black PLA blob in forground right and clear PVA blob in back zone of the Y calibration grid. On an actual printed part you can see the pause blob has returned part way through print raft support layer (bottom arrow) and then again 3/4 way through the print (see top arrow) 2.0 Auto leveling Sequence It never seems to fail on XY Calibration when it does the array probe sequence but before prints the printer will get to almost the end of the pre-print probe sequence and then give an Auto Level Fail notification. Then when I simply hit retry it more often then not gets through the test probe sequence and successfully prints? 3.0 UI Glitchy, Freezes, Non responsive I have noticed that the UI sometimes hangs between screens, sometimes does enable action buttons to be blue ready for input (the sit on screen in grey passive mode for a while) and when you press the up and down arrows on XY Calibrate the software will beep to recognize the input but NO action is transferred to the bed level adjustment drive? Any help on fixing these issues would be greatly appreciated. Neil
×
×
  • Create New...