Degs

@gr5- I Can see post processing is very usefull. I just have to remember to check everything. Thanks gr5

@gr5 @ahoeben - You found it guys.... How dumb am I...!!! There's a post processing script running for temp changes. I must have left it active after I did a temp tower. Didn't realise it kept the script running after closing Cura and then opening a new file. Changes 4 degrees every 10mm. Ooops. Sorry guys. Just looked over the gcode again. Don't know how I missed the post processing comment???

No not dual. It would show in the gcode. The Nozzle temp changes are not so random. The temp is set to 212 in Cura and at layer 98 it bumps it up to 226. Then from there on it drops the temp 4 degrees every 100 layers. Could it be a bug? Only just noticed this recently as I've just started to do larger prints. Thanks.

Cura seems to be adding random temp changes to my gcode. M104... I set to 212 and after some time into the print the temp will change from 212 to a range of temps from 174 to 226. Seems to be happening every 100 layers.I've attached gcode file generated from Cura 3.4.1. I have to remember to edit before the print. No big deal, as long as I remember. Any ideas. Thanks Degs SE-14R_-_Barrel.gcode