mzcukier

@LaserBrain - Thank you very much for the insights. I will be adjusting the settings as needed.

Hi @LaserBrain, I am seeing very similar issues. My calibration cube measurements are almost identical to yours. I am willing to put in the time to get the calibration correct. Originally I was looking for a way to modify the stepper steps/mm as that is what I have done on other models but I don't see a way to send Gcode directly from Cura to the S5. Can you tell me what settings in Cura you adjusted to improve the accuracy of the print? I am not looking for +/- microns but 0.2 mm is not good enough for this level of machine. Thanks!