Jump to content

kahuna3d

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

1 Neutral

Personal Information

  • Field of Work
    (Product) design
  • Country
    US
  • 3D printer
    Other

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Deleted Cura and prefs/cache and reinstalled - same issue and some new eerie stuff ? Fired up MatterControl and it printed the best adjustment knob I have ever seen without a glitch ? Cura was a bit funky from the get-go ? I can only summarized Cura 3.4.1 isn't savvy with Mac OS X 10.9.5 and CR-10 ?
  2. Too much heat, poor cooling (?) ~ layers can't cool before next pass and they don't 'weld' together (and check/double check bed leveling) That has happen to me (on more solid pieces, so mostly bottom was like that), but learned to "KISS" it ? - "back to basics" - try a simple print with simple default settings, then tweak up slowly as you learn what works on your set-up/prints ?
  3. Just printing adjustment knobs for my CR-10m, after the second print started I looked at the Cure window and the Monitor tab showed bad/wrong info, 100% done, 0 estimated time, print time is working, can abort/pause/ go to Prepare tab. Can't monitor, but printer printed the piece fine - closed Cura and relaunched - started printing a third piece and same thing happening, not sure how long into printing it does this as I'm busy "multitasking" ? - freaky man - It's printing now so don't want to disturb it - Cura 3.4.1 / Mac OS X 10.9.5 / CR-10m / recommended slice set-up - will likely delete Cura and prefs and reinstall, then print a test cube or something - Anyone seen Cura do this? ?
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!