Hello Everyone,
I'm having an issue with my Ultimaker 2. I had a print running that quoted 21 hours to finish. About 1/3 of the way through, the filament ran out and I did not catch it. So it continued to "print" for about 14 hours with no filament running through the nozzle.
Since then, I cannot get the printer to print. The filament will not stick to the plate on the first layer.
I've done several Atomic Method cleanings in the nozzle, i've releveled the build plate several times, and reinstalled the filament a number of times as well.
Below you can see a video of a print attempt that I just made. This is with stick glue on the build plate. I've tried a few different glues and also a clean plate without any luck.
I also had to increase the temperature of the nozzle to 230C for PLA. It was set at 210C prior to the incident; but after, filament would not extrude at that temperature.
Any tips or suggestions on how to proceed?
IMG_2628.m4v.zip