Jump to content

Hardlec

Member
  • Posts

    2
  • Joined

  • Last visited

Everything posted by Hardlec

  1. If I added the following to my cura starting g-code, would it lower my nozzle .25mm and build up from there? G1 Z -0.25 G92 Z0 is .25 millimeters a good place to start or would .1mm increments be better?
  2. A solution of vinegar and water will clean glass very well with no dirt-releasing additives that impede adhesion. If you are worried about a tape seam, make a deliberate overlap of about 1 cm. With an exacto knife or similar tool and a metal straight-edge, make a cut all the way through both layers. Peel the tape back and remove the 5mm wide strips. The wider pieces will fit back together very precisely. Stencil adhesive can be found in most craft stores. A thin layer on the bed will encourage the plastic to adhere, but stencil adhesive will not form a permanent bond. Stencil adhesive is designed to hold a stencil in place, keep paint from flowing under the stencil, and allow the stencil, often a delicate thing, to be removed and re-used.
×
×
  • Create New...