UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Hallo Kurt!
In Cura (bei mir 4) gibt es im Menü den Punkt "Erweiterungen > Nachbearbeitung G-Code ändern". Im sich öffnenden Fenster "Ein Script hinzufügen" auswählen.
Dort findest Du dann zur Auswahl "Filament Change". Dort bei "Layer" einen gewünschten Wert eintragen ab welcher Schicht das Filament gewechselt werden soll. Der Druck unterbricht dann und der Druckkopf fährt vom zu drucken Objekt weg.
Hoffe ich konnte etwas helfen.
Gruß
Matthias
Hallo!
Bin ich Blind oder gibt es in CURA 3.5 bei den Einstellungen den Punkt "Material > Durchmesser" nicht mehr?
In CURA 3.4.1 ist er noch einstellbar.
Kann das wer bestätigen, das dieser Punkt fehlt in CURA 3.5 ?
Gruß
Matthias