Jump to content

AMTech3d_Tech

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Field of Work
    Engineering
  • Country
    EG
  • 3D printer
    Ultimaker 3 Extended
    Ultimaker 2 Extended +
    Ultimaker 2
    Ultimaker 2 Go

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. ok sure thing is this borad is dead not connecting to usb but still it has the d7 led on when power is connected i better get another new board thanks @gr5
  2. Well i have the ultimaker 2 3d printer i updated it to 2+ with the upgrade kit later on after a lot of successful printing i found that the cooling fans not working well so i check the wires and ports on the board and there was a dead connection at the printer head soldered the junction and it worked for a good time later o i found that the fan 5 volt not wokring so i tried to change it and while iam doing that i accidentally short circuit the wires and now the board is dead at all ... doesnt wont to open..only the on light led is on no connection to the laptop...no TX RX leds working and no display working
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!