Jump to content

ripfree

Dormant
  • Posts

    2
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other
  • Country
    US
  • Industry
    (Product) design

ripfree's Achievements

0

Reputation

  1. I found the setting. It's a % number of the normal flow for all other layers. Mine was set at 100%, so I gingerly changed it to 95%. It seemed to slip even more. Am I right is assuming a smaller percentage should be less flow?
  2. Hi, in Cura, is there a way to slightly slow down the extruder feed rate just on the first layer? Mine slips every once in a while, but only on the first layer. I think that's because the the nozzle is slightly lower sometimes and impedes the flow. But it's not low enough to keep the first layer from printing fine. I think the z offset isn't the best way to regulate the first layer flow in a fine way. That would be too coarse a "lever" to pull. So, can I slow down the extruder feed stepper motor just on the first layer? Thanks!
×
×
  • Create New...