Biomike

Ask and you shall receive. I've attached pictures of what it should look like, and then what actually comes out.

AND on top of being so comprehensive that it should be required reading, it also solved my problem. The rear fan wasn't working. Swapped it out for a new one and it's working like a charm! Thanks for all the help!!!

Hi all, I just cleared a really big clog (had to take the head apart actually) and had a great first print. Since that one nice print, I'll start a print and it'll work fine for about 4-5 layers and then start underextruding. I've done the atomic method multiple times, and it comes out clean. Any suggestions? Thanks in advance for any words of wisdom.

I'm using Cura to slice a square with 2 open sides (it's a lid for a box to hold a small component) and Cura is consistingly slicing it strangely. It only lays a brim down for half of the shape, then will try to lay down midair filament in the regions without a brim. Obviously, not good. Any tips/tricks/suggestions? Thanks in advance for any advice.