UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Paste this address in your browser to verify http://192.168.0.105:8080/?action=stream.
Run Cura connect.
If the wifi is working and the camera runs in a browser it's a cura configuration conflict, if not then guess like I do and replace camera hardware. 🙂
Solved,
Cura connect config files were corrupted, factory reset and run the connect setup.
Use this address to test your camera connection http://192.168.0.105:8080/?action=stream
Mine did the same brand new.
Fan door would flop open, due to weak magnets.
Not as ugly as yours but it did push the glass off and jammed the Z motion.
Had a deadline to meet so had to overnight a new printhead and cores. $600 +
It's ridiculous not to have a pause signal sent when the fan door is opened.
Just had to replace the Wifi card and now the camera has quit...
love the warranty, support its great..... I'd rather not have to replace parts every month.
UM3, camera blank after replacing wifi card. Can connect and send prints, but no video. Monitor flashes about every 2 seconds from "grey available" to "blue with the progress bar.
Thanks for looking!
Firmware is latest, Cura 3.6 beta.