UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Thanks for the reply I will try to print it again with lower temps, I was running it quite slow 30mm/s at 195 celsius, this pla sticks to itself quite well even at 180 I will try higher temp at first layer and then drop the temp, thanks again
Hi all I've encountered a problem while printing in place, what it is I've been printing a fidget cube in pla with 0.4mm nozzle the first one came out fuzzed in some places so I decided to change the extrusion multiplier it worked but it created a different problem the pins that were printed vertically are looking good but the ones printed horizontally are too small/loose as shown on the pictures, is there a way to adjust the extrusion for the different parts of the object or is there a setting I could change to avoid parts fuzzing while keeping the extrusion the same ?