Jump to content

Henri_Lens

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Field of Work
    (Product) design
  • Country
    GB
  • 3D printer
    Other
  1. The last version allowed the Zig Zag support to be angled so roofs etc can be supported more effectively. I did download 3.6 but then was alarmed when I saw this appeared to be missing from 3.6. I was so alarmed that I went back and downloaded the previous version and again re-installed it. Being able to angle the support is a terrific idea. In fact I had real trouble with roofs until this feature was introduced. Please don't drop it. I found it personally extremely effective. It is effective in the case where the roof filament runs in parallel to the support and therefore the roof filaments aren't supported. The only way to support roof effectively before this was to put in more robust support but it would then be extremely difficult to remove. I have been able to make some great horizontal roofs very easily and the support material is a doddle to remove. Honestly I hope you don't intend to drop it.
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!