joestefano

Thanks for the reply’s. I only asked because when I open a model in S3d it opens in the units it was created in. No scaling or plug in needed

Why can’t cura open a model in the units it was designed in? I design in inches using fusion 360 but have to use a plug-in to convert it from mm after I open it.

This needs to be addressed!

What is normal behavior of the material station at the end of a successful print that uses both extruders? Above states that it ”tries to unload” tonight I got an ER61 on bay B ext 1 and the filament stopped a few inches from the print head and the bed did not lower all the way. I was not there at the time but was surprised that the error did not turn off the heat bed

I am having the exact same problem. Just installed mine today. I had to unplug it to get it to stop!

Is it normal that I have to play with the adjustment of the feeder every time I change a spool of the same filament? Once again today I was replacing a spool of pla that was printing fine with a spool of the same pla. When it went to load it extruded a bit and I confirmed and began a print and no filament came out. I checked the filament and it had been ground down. I had to lessen the tension to get the filament to extrude. My concern is that I have a material station coming and I’m not sure it will work if I have to play with the tension every time a new roll loads.

SandervG, Any update on the availability of the Air handler and material station? I ordered it from a US distributor at the beginning of Oct. and still waiting. Rumor is that Ultimaker is having issues with the firmware.

I printed on my S5 using S3D and it printed as I expected. I am running the latest firmware. I noticed that the bed leveling routine probes the entire bed. Where is the routine stored? What would need to be done to get the bed leveling routine up-dated to only probe the area of the model?

can't seem to import a profile into 4.0 beta2,. Message say's it was imported but it doesn't show up on the list

Why can't CURA infill thin walls like the Master Version does? (1.15mm) With a single line? I cant imagine it is good for the structure of the printer (U5) to have a grand-mal seizure every time it has to infill a thin wall. Size text test.stl

Thank you, that worked

ahoeben, It seems that I have 2 sidebars showing up on my screen, one on top of the other. Only with the latest version of master. How do I get rid of your plugin? I have uninstalled/installed the master but it still shows up. It does not show up with the previous version.

What happened to the layer sliders with the latest version of Cura Master?

What is the proper way to stay current with your Master version? Should the old version be uninstalled first? Is there anywhere that shows the version number? About Cura?

With 3.6 I want to print with only Ex2. I thought if I select the model and then click on EX2 on the left side of the screen that would be it. However I found that I had to go thru my settings and select Ex2 where ever I had a choice. This did not work for me. I had to disable Ex1 in order to get it to only print with Ex2. Is this normal?