Jump to content

joestefano

Member
  • Posts

    46
  • Joined

  • Last visited

Posts posted by joestefano

  1. What is normal behavior of the material station at the end of a successful print that uses both extruders?  Above states that it ”tries to unload” tonight I got an ER61 on bay B ext 1 and the filament stopped a few inches from the print head and the bed did not lower all the way. I was not there at the time but was surprised that the error did not turn off the heat bed

  2. Is it normal that I have to play with the adjustment of the feeder every time I change a spool of the same filament? Once again today I was replacing a spool of pla that was printing fine with a spool of the same pla. When it went to load it extruded a bit and I confirmed and began a print and no filament came out. I checked the filament and it had been ground down. I had to lessen the tension to get the filament to extrude. My concern is that I have a material station coming and I’m not sure it will work if I have to play with the tension every time a new roll loads.

  3. I printed on my S5 using S3D and it printed as I expected. I am running the latest firmware. I noticed that the bed leveling routine probes the entire bed. Where is the routine stored? What would need to be done to get the bed leveling routine up-dated to only probe the area of the model?

  4. With 3.6 I want to print with only Ex2. I thought if I select the model and then click on EX2 on the left side of the screen that would be it. However I found that I had to go thru my settings and select Ex2 where ever I had a choice. This did not work for me. I had to disable Ex1 in order to get it to only print with Ex2. Is this normal?

  5. Replacing the aluminum build plate with a 2nd glass plate (which I already have) does not seem to be a fair exchange. I think there should be an option to select a credit equivalent for other accessories or filament. The cost of the aluminum plate has to exceed the cost of a glass one. 

    • Like 1
×
×
  • Create New...