johannessssss

Thanks @ahoeben, i will give this a go

@ahoeben: yes they are white for the ultimaker 2+connect and the S3 and yes they are in place. But thanks for your response

To bowden tubes of my S3 and two 2+connects keep popping off mid print. I already replaced both the collars and the tube with official ultimaker replacement parts and i am getting desperate! please help!

I have now tried to reproduce this issue on purpose and i was unsuccessful. after that i thought it was business as usual (printing successful prints with new SD cards). This morning i found that the issue reoccurred, resulting in the intended print being printed about 30 layers with an older (week old) print on top ("sort of" since it was damaged).

@geert_2 thank you for your extensive reply. I am no flash memory expert, but i guess something like this could happen. Although i formatted both sd cards every time before uploading a new .gcode after the first time this happened. I am going to do some experimentation with ejecting the old sd card faster, viewing in a .gcode viewer and print to try to evoke this problem in a controlled manner. With the new SD cards i have printed 2 projects successfully now.

@gr5 Thank you for your quick reply. Of course, your first mentioned steps with regards to repair and ejecting the SD card, I paid extra attention to the first time the problem occurred. I am going to take two fresh SD cards, view every uploaded .gcode with a gcode viewer. I will keep posting positive or negative results.

Dear Community, I have been using my Ultimaker 2+ with succes for a year now. However, recently my printer is starting to print my previous print atop my new print. More concrete, it starts printing the new print for about 20 layers and suddenly it starts printing the previous file. you can imagine that this does not go well and i end up with a pile of plastics. I switch sd cards everytime i start a new print. Does anybody have a suggestion about how to fix this? Thanks in advance