I am trying to use the gyroid infill as my model by setting walls to zero etc. I have also changed the infill line width.
I have attached a few pics one of what the print looks like in cura in layer mode, the failed print and the original model. I have tried printing this a couple of times and it has failed in the same way. I don't know if it's difficult to print or just an extrusion problem. The problems I have are that the change in infill line width isn't being followed, I set the part I want to be just Gyroid infill to 2.45mm infill line width in the per object settings and it seems to still be printing at .35mm. In places there is a perimeter wall though non is shown on the model. There are also two or three lines running through the print.
I have tried this on an Ultimaker 2+ and extended Ultimaker 2+.
Thanks.