Jump to content

masterkey

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Field of Work
    Engineering
  • Country
    DE
  • 3D printer
    Other
  1. I have also this problem. Filament is coming out while travaling over areas. This amount is missing at new start up. It's funny no one's ever noticed...
  2. Hello folks, I have the problem that at the beginning of each perimeter too little material is extruded. This creates gaps between the perimeters. I print Janbex Filament white PLM with 1,75mm and a printing temperature of 190°C. An Anet A6 printer is used. more settings in Cura 3.6.0: Filament setting. 1,77mm (measured) Layer high 0,2mm Speed 30mm/sec Flow 90% (with 100% it is not better) Nozzle size 0,4 Wall thickness 0,8mm I have searched a lot on the Internet, but I only find problems where the gap is always present. I have no idea why the gap is only at the beginning of a new line. What could be the problem? And how can I solve it?
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!