Jump to content
Ultimaker Community of 3D Printing Experts

trooperlite

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    US
  • Industry
    Engineering
  1. Thanks a lot for the tips! I've got my nozzle much closer to the bed now and everything is printing perfectly.
  2. Thanks for the reply, The picture I attached is the brim. Because of the weird overlap on that corner of the brim, it causes that corner to lift. As far as I can tell, it's only overlapping the first layer.
  3. Hello, I have an Ultimaker 2 at my office which I successfully used in the past. However, recently it's been having a problem where it slips at the point where it begins the print. Because of this, that corner doesn't stick to the print bed. Any insight?
×
×
  • Create New...