Jump to content

trooperlite

Member
  • Content Count

    3
  • Joined

  • Last visited

Everything posted by trooperlite

  1. Thanks a lot for the tips! I've got my nozzle much closer to the bed now and everything is printing perfectly.
  2. Thanks for the reply, The picture I attached is the brim. Because of the weird overlap on that corner of the brim, it causes that corner to lift. As far as I can tell, it's only overlapping the first layer.
  3. Hello, I have an Ultimaker 2 at my office which I successfully used in the past. However, recently it's been having a problem where it slips at the point where it begins the print. Because of this, that corner doesn't stick to the print bed. Any insight?
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!