Jump to content
Ultimaker Community of 3D Printing Experts


New member
  • Content Count

  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
  • Industry
    (Product) design
  1. I'm using the Ultimaker 2, and I changed the value of the printing temperature to 220°C, because it didn't print at 210°C, so all the print setup is like this: Layer height: 0.15mm Priting temperature: 220°C Build Plate temperature: 60°C Print speed: 42 mm/s So with this values I printed the 3D Benchy, but the layers are not looking good. I didn't care that it looked like that, beacause at least it was printing. So I tried to print a bigger piece that was like a cone, with 180mm of the maximum diameter, but it failed at 7mm of height and stopped printing.
  • Create New...