I'm using the Ultimaker 2, and I changed the value of the printing temperature to 220°C, because it didn't print at 210°C, so all the print setup is like this:
Layer height: 0.15mm
Priting temperature: 220°C
Build Plate temperature: 60°C
Print speed: 42 mm/s
So with this values I printed the 3D Benchy, but the layers are not looking good.
I didn't care that it looked like that, beacause at least it was printing. So I tried to print a bigger piece that was like a cone, with 180mm of the maximum diameter, but it failed at 7mm of height and stopped printing.
My next attempt was this piece, that is below, with this print setup:
Layer height: 0.15mm
Priting temperature: 230°C
Build Plate temperature: 60°C
Print speed: 30 mm/s
But it keeps priting bad quality of layers, so I don't know what can be wrong with the printer or the print setup.