Jump to content

frankie_um3

Member
 View Profile  See their activity

  • Posts

    14

  • Joined

  • Last visited

 Content Type 

Everything posted by frankie_um3

  1. frankie_um3
    Suddnely my both bondtech QR extruders doesn't work any more after an update, indeed the filament does not come out at all .. it just makes the skirt and then goes to extreme under-extrusion .. almost nothing .. before they were very perfect ..!! it is as if the steps x mm did not work .. there is under extrusion .. I checked via putty and everything seems to be ok ... firmware ultimaker 3 5.3.0.20211003
  2. frankie_um3
    hi to all.. i've a klipper gcode and i ve to print it with UM3 by cura... someone could help me to swap klipper to griffin gcode to let me print it?
  3. frankie_um3
    hi to all... is printcore cc 0.4 compatible with um3? is it red by cura for um3? i ve bondtech qr with steel seeder!!
  4. frankie_um3
    Hi i ve inverted blu and red (swap 1 and 4) as bondtech instruction.. motor in this way are dead, they just don't run!! please help me!!
  5. frankie_um3
    Hi to all.. i need to invert extruder direction in my ultimaker 3 by putty sfw because i ve installed bondtech qr upgrade, but they works in opposite direction! i ven't right hand, sio i can't change motor's pin in plug... i 'dd prefer to set them in firmware... does Someone know comand line to open correct file in the root where i could change this values? thank you
  6. frankie_um3
    Hi, what is command line by putty sfw for inverting direction of bondtech qr extruder? I don't know where are the lines showed in bondtech troubleshooting or Configuration.h in my um3 frw !! Please help me
  7. frankie_um3
    Me 2
  8. frankie_um3
    Hi, I need a cura profile for printing um tpu 95A with support by my um3!! Thank you
  9. frankie_um3
    Hi to all, What are the best settings for nylon with carbon fiber? And I must choose nylon in Um3 when I load that filament? Thank you and sorry for my english 😊
  10. frankie_um3
    Ok thx.. I can set also cpe+, better?
  11. frankie_um3
    Does Someone want to share best Cura colorfabb xt material profile? So I can import in Cura for my Um3.. And what kind of material I ve to set in Um3 when I load xt?
  12. frankie_um3
    Nothing.. All is OK, but doesn't start to print!
  13. frankie_um3
    Yes.. But also when I override it, the Um3 doesn t start, why?? Thx
  14. frankie_um3
    Hi i 'm using um3 and i ve problems with pva.. please help me.. i buy um3 for pva's supports!
×
×
  • Create New...