ARTFX23

Works like a dream, used for less than 500 print hours, Selling to upgrade to the S7 kit. https://www.ebay.com/itm/115761551625 Bid: $1000.00 Buy it now: $1,500.00 You pay shipping. Cheers, Markus

Cheers.

For various reasons my S5 is not networked. Can someone send a link so I can upgrade my firmware via USB......please!

I am having the same issue with a new S5 and it is the PLA that is not printing fully, the PVA is fine. Could it be the wheel is slipping, I noticed the material I am using does not have ridges and is perfectly smooth?

Was one of the suggestions from the US support group, connections inside and in back "look" good. I guess I have to take it apart and put a meter on it?

I think it is the actual probe itself, as the fault often happens before the glass is within 10mm of the nozzle. I am going to try a Firmware update, and then throw in the towel till the support staff gets in on Monday. To say the least I am a bit bummed as it is a brand new machine, I will say though, when running, she is a beauty....

Glass is spotless, I also followed all the advice on Leveling...... I am in an office with little or no RF and the printer is on a secure table.

I am having the same issue with a brand new machine. Did you find a resolution?

I am getting a persistent failure. "Nozzle Offset Probe Failed". This was happening occasionally right out of the box, but was resolved with either a bed leveling or a hard reset. Now it is constant and I can't print! I have replaced both Heads and did a Factory Reset..... Any help would be appreciated.

Cheers!

The CA glue works well, just ordered some Revell to do further tests. Is there a Tough PLA in Bronze, Tan or Light Brown, what makes it tough?

I am printing a few parts in Tough PLA Black and am looking for a permanent compatible adhesive to Glue them together after they have been printed.