Jump to content
Ultimaker Community of 3D Printing Experts

rek

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Field of Work
    Other
  • 3D printer
    Other
  1. Thanks PeggyB Thanks for confirming. I found it, I'm using Cura 3.6.0 and 'Z Seam Alignment' is in the Shell section of 'Print Setup'
  2. Defeating the dreaded "Z Scarring" In Cura In Slic3r, there is a function located in Print Settings/Layers and perimeters/Advanced/Seam position that allows you to randomize where the entry points to each layer will be, eliminating z-scarring. Is there a comparable function in Cura? Now that I've configured Cura, it is printing better than Slic3r but I am still getting the z-scarring.
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!