Jump to content

ApexFPV

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Field of Work
    Education
  • 3D printer
    Other
  1. Anyone able to help with this issue of the outside seen in the photos? I have gone up and down by 20 degrees, increased flow in cura by up to 120%, slowed the prints to 20mm/s, changed the nozzle size (Incase it was wrong) from 0.3 (which it is labeled) incrementally up to 0.5, I have used calipers to check the filament diameter and adjusted accordingly; all with the same results. Anyone have ave any other thoughts?
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!