Jump to content
Ultimaker Community of 3D Printing Experts

nivek70

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Field of Work
    Engineering
  • Country
    FR
  • 3D printer
    Other
  1. Hello everybody, I currently try to adjust some profiles for my new Prusa i3 MK3 on Ultimaker Cura 3.6. After two weeks test, I have really better results with Cura than with Slic3r-PE, but I have still little troubles and I can't find the solution him self, I need your help. On the top layers, there are some printed lines over extruded which gives a bad appearance while the rest of the part is great. This lines appear mainly on the last line printed before the end of print, or after a travel to begin a new part of the layer further on the surface. I think this trouble less occur on plain surface where it's possible to print all at once (but not sure, I should test it). Someone have an idea to reduce (or better, removed) this over extruded lines ? Thank in advance for your support ! Note : it's not a scare that comes from travel ! I was this problem last week but I resolved it quickly with combing mode set to "not in skin".
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!