Hello everybody,
I currently try to adjust some profiles for my new Prusa i3 MK3 on Ultimaker Cura 3.6.
After two weeks test, I have really better results with Cura than with Slic3r-PE, but I have still little troubles and I can't find the solution him self, I need your help.
On the top layers, there are some printed lines over extruded which gives a bad appearance while the rest of the part is great.
This lines appear mainly on the last line printed before the end of print, or after a travel to begin a new part of the layer further on the surface.
I think this trouble less occur on plain surface where it's possible to print all at once (but not sure, I should test it).
Someone have an idea to reduce (or better, removed) this over extruded lines ?
Thank in advance for your support !
Note : it's not a scare that comes from travel ! I was this problem last week but I resolved it quickly with combing mode set to "not in skin".