Orthopus
-
Posts
3 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Orthopus
-
-
And I'm using Ultimaker Cura 3.6.0
Thanks !
-
Hi everybody,
We've just bought an Ultimaker 2 extended + and being new to the 3D printing world we are trying to print out simple objects with different filaments. I couldn't figure out the right settings to print out a micro catapult from Thingiverse with FormFutura TitanX filament (datasheet).
Here are the settings of my last try :
- Material : FormFutura TitanX White
- Printing T° : 260°C
- Build Plate T° : 85°C
- Fan Speed : 20%
- Regular fan speed : 5%
- Max. fan speed : 20%
- Nozzle Ø: 0.4 mm
- Layer Height : 0.15
- Infill density : 30%
- Wall Thickness : 2 mm
- Flow : 106%
- Retraction : enabled, +/- 5 mm
- Speed : 40 mm/s
- Build plate adhesion : Raft
- I've thermally insulated the whole printer
With these setting I got :
- poor layer adhesion giving a very weak catapult
- poor printing precision
- no warping
You can find enclosed some pictures of the catapult printed with these settings.
Thank you so much for your help !
Thibault
Need help to figure out printing settings for FormFutura TitanX White ABS filament
in Improve your 3D prints
Posted
Hi Smithy,
Thank you for your answer.
I will change the minimum layer time from 3s to 10s.
About the printing temperature I've followed the guidelines from FormFutura. They advice temperature from 240°C to 260°C and I've tried 240, 250 and 260°C. I will try again at 240°C.
I've enclosed the printer in a chest made from heat insulation material. I felt the temperature inside was much hotter than the room temp so I will lower it down.
I've set the flow to 106% following guidelines from FormFutura, I will set it back to 100%.
I will try again with the settings you advised and keep you updated.
Thank you !