HI
I have been using cura 15.04.6 for a while and decided to try 3.6 after 15.04.6 couldn't render a vase.
I am using the robo 3d r1+ and octoprint
I checked the start gcode to make sure I saw the g29 auto level.
but when it went to print it did not execute the g29.
if fact it just started printing in mid air , at the height the nozzle happened to be at.
in cura 3.6 the default gcode flavor was marlin.
IN cura 15.04.6 the default gcode flavor was reprap(marlin/sprinter).
should I change the gcode flavor to reprap??
or is there something else causing this problem?