khutchinson22

I had saved my settings from a previous version of Cura and the command (G29) has not changed. Only the response to the command. I appreciate the clarification. I will dig a little deeper with this new information and see what I can find. Thank you for taking the time to explain it.

Is this not the forum I would use to ask about Cura software? I apologize if I am in the wrong place. I did not think this question Printrbot specific but more software related. It appears that is not the case....? I do not have an LCD display and I am unsure how to check my firmware version. I have tried several different gcode commands that are designed for bed leveling and none of them have done what I needed them to do. It will either check 3 points or none.

It looks as though I need a program called Arduino and then use the .hex file created there to upload that firmware to the printrboard. Does that sound accurate?

Sorry, I meant to include that. Cura is fully up to date. I am using a Printrbot Simple Metal with a F4 board. I do not know which firmware I have on it and I am not really even sure how to update the firmware as Printrbot is no more and I never could get their firmware tool to work.

I run auto leveling prior to every print and within the last couple of builds (I think) it began only referencing 3 points on the bed during leveling instead of the previous 9. My bed is uneven and does not have manual level screws (not a Ultimaker) so the 9 point levelling is necessary for my needs. Ive searched extensively and have turned up nothing that allows me to alter the gcode to allow for added leveling points.