Hi everyone.
The company i work in recently bought a Ultimaker 3, since we are going to make some End-Use holder for a
spirit bargun, I was told that the Ultimaker was the best 3D printer to go for, so we didnt need to use too much time
on setup.. I had just struggles abit, making the print "perfect"
Yesterday i finnally started up to print 6 pcs at the same time, but 30 min into the print, 1 of the units start to
warp in the corner.
I then restarted the process and instead of printing 6 i set it to print 3.
It then started again, but this time i noticed that the first layer wasnt really smooth, how can this be?
I have attached a picture of the layer, the nozzle of the Printer is covered in black filament...
I am printing these with Ultimaker PC filament.
Regards Nicolai