Jump to content
Ultimaker Community of 3D Printing Experts

avengre

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Field of Work
    Medicine
  • Country
    US
  • 3D printer
    Other
  1. Hello, I've tried out Cura 4.0 after using Cura 3.6, the UI is fantastic and much smoother; However, It seems like the "Machine Settings" section for Extruder 1, Extruder 2... no longer exists, specifically the section with the Extruder Start G-code / Extruder End G-code. This is important in my case as when using a dual extruder setup, the extruder will heat up the standby nozzle over top the print (or stop and wait for heating, and melt the print below it), Right now Issue a G1 X0,Y0 to move to a safe heating spot... Is there a plan to put in per-extruder g-code stuff again, or at least the ability to set a 'heatup position' in Cura 4?
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!