Jump to content

avengre

New member
  • Content Count

    1
  • Joined

  • Last visited

Everything posted by avengre

  1. Hello, I've tried out Cura 4.0 after using Cura 3.6, the UI is fantastic and much smoother; However, It seems like the "Machine Settings" section for Extruder 1, Extruder 2... no longer exists, specifically the section with the Extruder Start G-code / Extruder End G-code. This is important in my case as when using a dual extruder setup, the extruder will heat up the standby nozzle over top the print (or stop and wait for heating, and melt the print below it), Right now Issue a G1 X0,Y0 to move to a safe heating spot... Is there a plan to put in per-extruder g-code stuff again, or at least the ability to set a 'heatup position' in Cura 4?
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!