I finally decided to upgrade from trusty Cura 4.8 to 4.10. I don't remember having to reconnect all my Octoprint printers with previous upgrades but I managed it.
I have a model that I want to do a filament change on and decided to try the pause at layer height (Extensions - Post Processing - Modify G-Code). The print was looking great and I was quite happy when the printer paused allowing me to change the filament. I couldn't find a resume option on the LCD but I did notice the Cura Monitor was showing the print was paused. So far so good right?
When I selected resume in Cura the print head crashed into the print. It was making so much noise I was busy aborting the print before something got broken and didn't notice what the LCD display said. It was almost as if the Z axis went to zero on the way to resuming the print.
Here's the settings for the Pause at Height script:
Here are my specs.
Printer: Ender 3 with V4.2.7 Silent Board
Marlin: Shipped Version w/Silent Board
Send: M115
Recv: FIRMWARE_NAME:Marlin Creality 3D SOURCE_CODE_URL:https://github.com/MarlinFirmware/Marlin PROTOCOL_VERSION:V1.0 MACHINE_TYPE:Ender-3 EXTRUDER_COUNT:1 UUID:cede2a2f-41a2-4748-9b12-c55c62f367ff
Recv: Cap:SERIAL_XON_XOFF:0
Recv: Cap:BINARY_FILE_TRANSFER:0
Recv: Cap:EEPROM:1
Recv: Cap:VOLUMETRIC:1
Recv: Cap:AUTOREPORT_TEMP:1
Recv: Cap:PROGRESS:0
Recv: Cap:PRINT_JOB:1
Recv: Cap:AUTOLEVEL:0
Recv: Cap:Z_PROBE:0
Recv: Cap:LEVELING_DATA:0
Recv: Cap:BUILD_PERCENT:0
Recv: Cap:SOFTWARE_POWER:0
Recv: Cap:TOGGLE_LIGHTS:0
Recv: Cap:CASE_LIGHT_BRIGHTNESS:0
Recv: Cap:EMERGENCY_PARSER:0
Recv: Cap:PROMPT_SUPPORT:0
Recv: Cap:AUTOREPORT_SD_STATUS:0
Recv: Cap:THERMAL_PROTECTION:1
Recv: Cap:MOTION_MODES:0
Recv: Cap:CHAMBER_TEMPERATURE:0
Recv: ok
Octoprint: 1.6.1
Did I forget anything? Any ideas if I did something wrong or is just not supported with my configuration?
