Jump to content

vkmicro

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    US
  • Field of Work
    Other
  1. alright, i'll try that too. Thanks again. Appreciate your help!
  2. Hey everyone. So I've recently got into 3D printing. And i've run into an issue i can't figure out how to resolve. I use Cura 3.6.0 While sliding prints with large flat areas, especially ones which have a flat area and then another layer on top of it (think of a badge, where you have a flat part and then stuff extreded out, i don't know how to better explain it, pictures will show), anyways. Cura leaves GAPS in the layer print, and then fills them in last... which is weird and results in some very ugly and unpleasant flat layers. please take a look at the pictures and I hope someone can tell me which settings would cause this and how to adjust the settings to avoid these issues. Thanks!
×
×
  • Create New...