Hi, I have been trying to print a large version of the one piece elephant so I scaled it up as large as I could in the latest cura software to fit on my UM2. I have a raft enabled to keep the model as large as possible.
When I try to print the file it gets about 11mm up then stops with the trying to print outside the printable area message. I have checked the file on the SD card for errors and it reads back fine. I have also tried printing it twice and it stops in exactly the same place.
Looking at the file with an online viewer the only thin that I can see is that at times the print head is moving outside the printed model and I am wondering if it is this movement which is outside the area , but as it is not "printing" it gets passed the cura normal checks.
I have attached a zip of the gcode file.
Any help would be greatly appreciated.
Thanks
Bruce
UM2_big_Elephant.zip