Jump to content

PolyCraft

Dormant
  • Posts

    1
  • Joined

  • Last visited

Everything posted by PolyCraft

  1. Hi all, I'm new to the forums and fairly new to the S5. I'm having a bit of trouble getting the S5 to find and use the Lift Switch properly, and it seems to have started with a 20 hour print job (Tough PLA, PVA) I had on recently. The parts had warped, the print bed had been knocked about 1 inch to the right, the silicone cover on the print head had been pulled out, and the print was offset on the X and Y axis part way through (but despite all of this it was still trying to print!). Just to be safe I performed a full maintenance cycle, including XY offset calibration and a lift switch calibration, but I'm still having issues. When I set a print to go the print head moves to the lift switch to change print cores, but seems to miss on the Y axis by about an inch (toward the back of the printer), even after all of the maintenance and calibration. Does anyone know why it might be doing this, and what I can do to fix it? Thanks in advance!
×
×
  • Create New...