nocturnalit

I am chasing a solution for the exact same thing! It still does this behaviour in 3.6 At the moment I manually edit the gcode.

I am printing small battery caps in TPU and can fit 8 on the bed at once. Because I'm printing TPU which strings quite a bit I am using the 'print one at a time' setting in Cura. The prints come out great most of the time however sometimes between the objects it waits for the bed to reach temperature it oozes too much material which interferes with the next print. I have been able to work around this by manually searching the gcode and deleting all instances after the initial warm up period but hoping that there is an easier way? Thanks