dotnetrob

Ok, figured it out, I am guessing something got messed up after one of the upgrades. Was running 4.0 until about 3 weeks ago, upgraded to 4.5 back then. Upgraded to 4.6 yesterday. Profiles must have gotten messed up during all of this. I changed profile setting to 99mm and resaved the profile, than changed it back to 4mm and saved again and it started working. Now the value changes when I switch profile or material.

That would make sense but something still seams amiss. My profile is set to Retraction distance is 4mm. I have two materials I am switching between for testing, one is set to 2mm the other is 3mm. When I change to either material it changed it to 10mm... I don't see where its getting the 10mm from.

When I switch between materials the print temp, build plate temp, standby temp all change to what is set in the material print settings. But the retraction distance and speed are not changed? Not sure about fan speed. Is this correct? Shouldn't the print values be replaced by the material print values when I change materials? If not why even have these values in material?

Have a similar issue on PC, the screen is re sizable but sometimes the text shows up blank or overlapping. If is shows up blank or overlapping the only solution is the re size the window as big as possible and eventually all the text is visible.

Does the Cura Backup plugin backup printers? Wanting to backup my start/end g-code do I don't lose it. Can't find way to export printers in cura, was hoping backup may do it for me. I can't find anything that says what is backs up.