Jump to content
Ultimaker Community of 3D Printing Experts

maker-rolf

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. @Smithy thanks for the quick response. I tried different speed settings in Cura, but the result was not the one, which I expected. So I focused on the hardware: with the XY-test, I found out very fast, that the bolts, which fix the X- and Y-servos to the housing, were completely loose. After fixing, the distances were gone and the print looks very good again. The attached GIF shows the situation before fixing the bolts.
  2. I am using an Ultimaker3 and some FormFutura filament. Does anyone have an idea, what is wrong with my setup, that I get this distances in my print? Thanks for any help!
×
×
  • Create New...