I wanted to connect our printer (UM S5) from the Wifi connection to the newly installed Ethernet.
For this I have deselected the Wifi and wanted to dial Ethernet. After a few seconds, the switch was reset to gray and no Ethernet connection was available. The Ethernet line was tested and used with other devices. Repeated attempts were unsuccessful.
Then I reset the Cura Connect settings. A wifi connection could be set up, but an ethernet connection could not be established.
I've reset the Cura Connect several times to test whether the ethernet can be enabled without a wifi connection. That was also unsuccessful.
Finally, I reset the printer to factory defaults and repeated all previous tests to find out that I can no longer set up a Wifi connection. The menue stops at the Create Hotspot window. The progress bar has gone through to the end, but there is not a hotspot enabled, neither a message on the printer nor Wifi to find.
My guess is a firmware issue, because until yesterday and before resetting to factory settings, the Wifi connection was possible.
I uploaded the latest firmware last week via Wifi. (Version 5.2.8.20190320)
Is there a way to replay the last working or a newer firmware?