Jump to content
Ultimaker Community of 3D Printing Experts

justus2342

Member
  • Posts

    2
  • Joined

  • Last visited

justus2342's Achievements

0

Reputation

  1. Hello everyone, talking about dual-extrusion, I would like to make my start-gcode only heat up active hotends. Therefor I would like to to something like this in my start-gcode: {IF HOTEND0.ENABLED=1}M104 T0 S{material_print_temperature_layer_0,0}; set temp for hotend 0 {IF HOTEND1.ENABLED=1}M104 T1 S{material_print_temperature_layer_0,1}; set temp for hotend 1 Is this possible? What would be the right syntax? If its not possible in start-gcode, is there any other way to achieve it? Thanks and all the Best, Justus
×
×
  • Create New...