Hello everyone,
talking about dual-extrusion, I would like to make my start-gcode only heat up active hotends.
Therefor I would like to to something like this in my start-gcode:
{IF HOTEND0.ENABLED=1}M104 T0 S{material_print_temperature_layer_0,0}; set temp for hotend 0
{IF HOTEND1.ENABLED=1}M104 T1 S{material_print_temperature_layer_0,1}; set temp for hotend 1
Is this possible? What would be the right syntax?
If its not possible in start-gcode, is there any other way to achieve it?
Thanks and all the Best,
Justus