willbill

Im using the right voltage (24v) heater. what do you mean has a too big stored heat capacity? could the sensor be the problem seeing as ive replaces the thermistor as well? and even prior to replacing it it was jumping over the temperature.

I recently replaced the heating cartridge in my Tevo Tornado with a 24V heating cartridge and now when i try heating it the temperature jumps to at least 40 degrees above what I set it. Then throughout the print the temperature will fluctuate at least ten degrees any ideas? I understand this is probably not the best place to ask seeing as my printer isnt made by ultimaker but ive searched for hours trying to find a solution and i cant find one anywhere. any help is appreciated! Thank you in advance!