Jump to content

Warrior24

Dormant
  • Posts

    2
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Warrior24's Achievements

0

Reputation

  1. I had Cura 4.2 installed, and whilst using it, the new version available message came up.. I decided to update to Cura 4.2.1. I accepted the option to remove the previous version and completed the installation of Cura 4.2.1. It turned out that doing the above was not a good idea, as now Cura 4.2.1 will not open at all on my P.C. I have installed and uninstalled it about four times, and also cleared the Registry of Cura entries, etc, etc, but it just won't run at all on my laptop. Four or five previous versions of Cura, up to and including Cura 4.2, have installed and run with very few issues, so I am at a loss as to why the latest version will not run. Would you be able to help? Thanks.
  2. I have entered my own Start Gcode and End Gcode into the printer settings, see attached screenshots. However, as you can see, Cura also adds its own lines of Gcode that I don't need or want. Does anyone know where these lines come from, and how to prevent them happening?Thanks.
×
×
  • Create New...