Jump to content
Ultimaker Community of 3D Printing Experts


  • Content Count

  • Joined

  • Last visited

Everything posted by naten11

  1. Thanks for the information @smartavionics! So is this behavior automatically added once the gcode is compiled and unable to be turned off? Would downloading a previous version be the only way?
  2. So I'm trying to figure out which setting might be causing this, but can't seem to find it. After updating to a new Cura version, I started noticing my extruder moving to the same starting position every new layer. What I mean: After a layer is finished printing, regardless of where it finishes it always goes back to the same place on the print; due to sometimes long travel distances to get there and certain retraction settings, this is causing that certain location to have less material. What I had: The new layer used to start printing right where the previou
  • Create New...